New Caprice - Discussion forums

Blow off valve flange is welded onto the 4in spectre pipe. I put it about 6in or so before the maf. I read that's about the best placement for it.

I put the meth nozzle in the silicone 90 before the throttle body. I used this piece from Amazon and flap disked it down until it was as thin as I could get it so the nozzle would be exposed and hopefully be able to have a good straight spray into the TB.

I had the down pipe off to weld my o2 on, so I painted it gloss black with some hightemp paint. It looks a little more stealth now .

I plan to wrap this too up to right before it comes out of the fender.

Trunk looks clean again!

Finally got the meth line ran to the front, mounted the pump in the spare tire well.

CrashTestDummy wrote: ↑Mon May 13, 2019 12:08 pm I'm surprised the rear tires don't light up every time you open the trunk with all those stickers!

So am I!

I had to pull it out of the garage so I figured I'd get a picture. Seats are out to run the meth injection wires. If you're on the Facebook page I posted an idle video!

Haven't even plugged HP tuners in yet and I already gained a few HP

Here's a picture with the downpipe on. I was gonna plumb the wastegate into it, but I think I'm just going to cut another 2in hole and dump it right next to the 5in. Also im going to paint the downpipe black so it blends in a little better 😂 Also I started wiring the meth injection. The AEM kit make...

Here's a picture after the heat gun treatment. The gauge was a little difficult to get in. I sanded the hole a little and it worked fine.

I picked up this gauge pod on Amazon for $14. I heated it up with a heat gun and pressed it onto the dash to get it a little more flush. Here is how it sat before the heat. Link below if anyone is interested. GlowShift Universal Black Triple Gauge Console Dashboard Pod - Fits Any Make/Model - ABS Pl...