New Caprice - Discussion forums

Ok kids, here goes...I imported these Holden wheels from Australia last year. They are genuine Holden WM Caprice Series II zero-mile take-offs. Square set-up: 18X8, 5X120 bolt pattern, 48 MM offset, 66.9 MM hub bore, same as the PPV. They have some very light scratches and a couple nicks, assuming f...

Probably a long shot, but I hate throwing stuff away. I've got the mounting plates for a Pro-gard cage/partition, self tapping screws, and B pillar trim pieces I just pulled out of an '11 9C1. $10 and you pay for shipping. I have a FedEx business account. There's a full service drop off close by. If...

My '11 9C3 has 36# on the label for all four corners. The few '11-'13 9C1's I've had go through my hands have all been 36 front/44 rear. As written above, most likely to compensate for the assumed added equipment in the trunk.

I have four steel wheels with Goodyear Ultra-Grips with 8/32" to 9/32" tread depth. The came off a Caprice from mid-state New York, so there is some surface rust, but no other issues. If you're interested, send me your email and I'll send you pics.

Thanks,

Ken

s/c'd cav wrote: ↑Wed Apr 24, 2019 11:23 am how much ? and is it for the WHOLE set up ?

Cav,

Yes, going to strip off the whole set-up. I'll send you a PM in a minute.

Absolutely! ....kinda makes me wonder what the hell was hooked up.

I'll be removing this stuff soon. Let me know.

Yes, 18x8. Same hub bore. Ok, good to know. I'll look there.

Thanks!

This old thread, fifth post down....

http://newcaprice.com/forum/viewtopic.p ... 91ac56325b

the offset has nothing to do with clearing the brakes , its all in the wheels design the steel wheel is lucky it clears the brembo's most factory holden wheels were not made to clear brembo's I was hoping that wasn't the case. :( Mechanic said spacers might work, so gonna try to head to the tire sh...