New Caprice - Discussion forums

Yup, that is how I understand it also.
The center wire is the positive, and the shielding wire is the ground.

NovaPPV wrote: ↑Sun Dec 16, 2018 12:27 pm Fairly certain bare copper is ground and the positive is the white insulated strand.

You asking me this question is the blind leading the blind, so good luck!

Here is the sport mode diagram for a 2017 Caprice from the same site. Seems the Caprice only has the sport mode button on a different connector of the BCM. https://imgur.com/a/dpOhdf1" onclick="window.open(this.href);return false; I used 2017 because on that site the 2014 diagram was clear...

You can try calling ACDelco Techline and asking for a VCI reconfiguration calibration for the BCM that would add factory remote start. There is a chance that could work. Would help if you had the option package designation for remote start to give them. I tried that route for my instrument panel but...

Found the 2014 SS TUTD wiring diagram on http://www.bbbind.com" onclick="window.open(this.href);return false; It is free to register there and they have TSB and Wiring diagrams available. Took a screen shot of it, posted it here: https://imgur.com/a/FmmSWqb" onclick="window.open(...

Lets see a picture of the solder job. Steve, what do you think about using a crimp on ring connector and a nut and bolt to attach the wires to the board in the future for guys without a connector? Do they make them small enough to use here? Seems to me it chould be easy enough to do for most and av...

Do you have anything else that outputs video with an yellow rca you can plug into the video in to test it? I would start there. I was able to use my phone, but anything with a Composite video output should show on the screen. OK so I soldered the AUX cable onto the right pins. Pulled power from igni...

My understanding is that if you connect the white cable to position #3 then that is your ground for the backup camera and the red cable connected to position #4 would be your positive cable. Honestly though, I'm not sure if the White Neg cable is necessary based on those that actually had the 20 pi...

Has anyone looked at this solution for putting in an aftermarket radio yet? Looks like its for Series 1 cars, G8 style, and single zone climate. Seems you would have to do a downgrade to series 1 single zone of course. This site has it for $349AUD https://automotivesuperstore.com.au/aerpro-fp9350bk&...

New tire time again, and looking at the Nokian ZLINE A/S. Only $126 each at walmart. Nokian ZLINE A/S Performance Radial Tire - 235/50R18 101W https://www.walmart.com/ip/Nokian-ZLINE-A-S-Performance-Radial-Tire-235-50R18-101W/201443227" onclick="window.open(this.href);return false; Any one...

The wire shielding isn't attached on my setup. Just the 3 wires in the cable I used as it was a headphone type cable with a shared negative The negative went to the connector cover/shielding, and the positives were attached 1 to each positive pin. The wire shielding was just clipped back and not con...