It has begun

[Gerome]

Good deal on what I call a massive undertaking . Can not wait to see the end result .

[greasychevy]

couple more just cause.

Ill be going back to the factory MAF having some idling issues i think its due to the step up/down to/from the 4" LS7 housing. factory wont be as big of a step and has the honeycombs to straighten the air after the bend.

[greasychevy]

got on a dyno today. ran out of fuel injector at 5000 rpm. so that sucks. procharger said 60lb injectors were enough. o well. ID 1000s it is.
On the bright side 440whp running out of injector only getting up to 5k only hitting 7psi and having timing backed about halfway off. at 6200, 10psi, and with some fuel should clear 500.

[Gerome]

Would have loved to have seen that beast on the dyno . When are we going to get some video ? No video it ain't real . Lol

[greasychevy]

soon. i was going to video the final pull but we never got there... im ordering injectors tomorrow. then just gotta find time to put them in. Shouldnt take too long but its busy week or two for me. hopfuly in the next few weeks it will all be done.

[Gerome]

I understand being busy . Will be looking forward to the video .

[greasychevy]

Got my injectors installed today. Heres a short video for anyone interested. Sorry about the audio exhaust is too loud.

https://www.youtube.com/watch?v=TqyhbK5ZqAw" onclick="window.open(this.href);return false;

[Gerome]

That is sweet ! Man I have blower envy . Lol

[greasychevy]

i just hope the pump can keep up.

[greasychevy]

Ok. Tune is done. Only dynoed 490 not quit as high as i hoped but im going to blame it on the gas that was left over from earlier in the year. That torque though with the stall it flashed 595ftlbs in actuality its more like 550. shreds tires anywhere below 40 mph. Shortly after i got off the dyno the cops showed up because of noise complaints! haha.


http://youtu.be/As10J-Zi2To" onclick="window.open(this.href);return false;