Page 3 of 3

Re: Finally Tinted

Posted: Mon Feb 11, 2019 10:14 am
by xcidmigs
These headlights lenses don't come off? Almost all the newer cars I've seen now have the clear part as removable, using something like butyl rubber to seal which actually comes off pretty well and is easily replaceable, HD sells a nice roll of it for like $6 DId you have some strobe lighting holes put into yours?

Re: Finally Tinted

Posted: Mon Feb 11, 2019 10:26 am
by lastcall190
I would attempt to bake them and remove the lenses... but considering the cost of replacement lights if I muff it up, I'd rather have a spare before trying it. I noticed that when you look into the light from the backside, there are lots of small torx screws that almost seem that when removed, would allow a LOT of access to get maybe a small hand in there to clean them. If nothing else, I now see how damn easy it is to remove them once the bumper is off.

No holes from strobes but almost seems that the lens was burnt from the lights being on so much...? Difficult to describe without a pic.

The condensation issue was probably because of me being a dumbass as well as the highbeam bulb cover off for a long time (decided to take a nap at the bottom of the fender well for a few years).

Re: Finally Tinted

Posted: Wed Mar 13, 2019 2:14 am
by gregthrey
cerbomark wrote: Thu Nov 01, 2018 2:12 pm me too...
Image
Image
Image
These looks good, I think it will looks good on mine too. Planning to change it this week.

Re: Finally Tinted

Posted: Wed Mar 13, 2019 7:00 am
by cerbomark
Thanks.
They look dark here but they are not the limo dark FYI.