New Caprice - Discussion forums

The worldwide owner-to-owner online support system for the Chevrolet Caprice PPV
It is currently Sat Nov 17, 2018 9:28 pm

All times are UTC [ DST ]

Forum rules

This business venture is currently on hiatus. No new orders for parts are able to be placed at this time, nor is this site being monitored by the vendor. Forum is locked, discussion topics are left active for reference purposes. Unfortunately we have no idea at this time when the business will again be accepting orders.

Forum locked This topic is locked, you cannot edit posts or make further replies.  [ 3 posts ] 
Author Message
 Post subject: Fog Lamps
PostPosted: Mon Nov 16, 2015 9:07 pm 
User avatar

Joined: Thu Jul 17, 2014 11:17 pm
Posts: 204
Location: Jordan, MN
So I've been looking all over the forum thinking there should be a thread on fog lamps, and I can't seem to find one anywhere! Am I just missing it? I tried searching but apparently "fog lamps" is not a good enough search term. I know several cars have the lamps on them, so what do they cost and how do you wire them? Is there a new switch that replaces the current headlamp switch? Are there wires in the harness already meant for these lamps?

2011 9C1
2005 GTO

 Post subject: Re: Fog Lamps
PostPosted: Tue Nov 17, 2015 12:24 am 
Administration Staff

Joined: Tue Mar 19, 2013 11:30 pm
Posts: 1484
Location: Canton GA
Topic section - electrical

I did a search using "fog lamp" and got 68 topic hits (noting that the search "ignored" the term fog), you'll find it there.

Try this: viewtopic.php?f=21&t=19

Here's another that may shed a little more light....viewtopic.php?f=21&t=64

There are switches that can be used in place of the OE Caprice switch. The issue is that in so doing, to make everything work as a factory installed setup, a BCM (body control module) reprogarm is also required. I don't know if Chris White (GTP Prix on the board) has done this, or what it may cost. The alternative is to design a circuit that could emulate what the BCM does, using a relay, as some have done, or at least tried--not clear if it worked 100%.

In my own situation, a manual switch was installed--I can have high-beams and fogs on at the same time. Not ideal, and possibly not legal in some jurisdictions.

PPV does not have any of the wiring for this configuration.

Bill Harper

 Post subject: Re: Fog Lamps
PostPosted: Tue Nov 17, 2015 8:35 pm 

Joined: Wed Dec 31, 2014 2:58 am
Posts: 415
Location: Texas Hill Country
Figure on about $150 for the bezels, mounting hardware and wiring harness for the lamps. (Australia)
Figure on another $150 for the actual lamps (US any GM dealership)
I wired mine like Bill on their own switch through an ignition controlled relay so that they only will work with the key on and so that the amperage is not going through my switch and wiring. (I used one wire in the factory installed grill/siren speaker harness (4 wire harness) so that I did not have to run any wires to the engine compartment.

Garner Ames

1975 Pontiac Grand Am L77 - 14.82 @ 92.89
1991 Chevrolet C1500 L31 Vortec/5 Speed
2014 Chevrolet Caprice 9C1 L77 - 13.60 @ 105.87
SS Roto-Fab CAI, Solo axle backs

2015 Chevrolet Caprice 9C1 6.0L (owned by the tax payer in all of us)

Solo axle backs

Display posts from previous:  Sort by  
Forum locked This topic is locked, you cannot edit posts or make further replies.  [ 3 posts ] 

All times are UTC [ DST ]

Who is online

Users browsing this forum: No registered users and 2 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group