Page 1 of 2

2012 Part out

Posted: Mon Dec 02, 2019 9:06 pm
by Dfreehd
I have a complete car that i am parting out. Hood is Bad, Trunk is bad, Front fenders have dents but still plenty of good parts. I have listed a lot of parts on eBay under the username Randyfff3 but some of the parts may be easier to sell on here. 105k on this car still running and driving with clear title but i purchased for spare parts.
IMG_2836.JPG
IMG_2836.JPG (3.23 MiB) Viewed 10030 times

Complete spare tire kit $50 plus shipping to you.
IMG_2793.JPG
IMG_2793.JPG (1.67 MiB) Viewed 10030 times
Back seat $150 plus shipping
IMG_2799.JPG
IMG_2799.JPG (1.82 MiB) Viewed 10030 times
Front seats I have two sets. will sell foam, covers, frames, together or separate.
IMG_2802.JPG
IMG_2802.JPG (1.83 MiB) Viewed 10030 times
Rear door panels $100 each plus shipping.
IMG_2780.JPG
IMG_2780.JPG (1.81 MiB) Viewed 10030 times
IMG_2784.JPG
IMG_2784.JPG (1.97 MiB) Viewed 10030 times
Rear seat brackets. $50 plus shipping

Any misc interior trim, Seatbelts, Airbags,etc just ask or check to see if i have posted it on eBay.

Re: 2012 Part out

Posted: Tue Dec 03, 2019 3:55 pm
by Pursuit
Where are you located? Might help in the decision making for the forum members... :)

Maurice

Re: 2012 Part out

Posted: Tue Dec 03, 2019 6:09 pm
by Dfreehd
Located in Murfreesboro,TN (outside Nashville).

Re: 2012 Part out

Posted: Wed Dec 04, 2019 5:06 pm
by CrashTestDummy
How are the headlight modules? Looking to pick up spares.

For others, the metal frames around the rear quarter windows are 'frequent flyers', literally and figuratively. Grab them, even if no one asks for them today.

Re: 2012 Part out

Posted: Mon Dec 09, 2019 8:39 pm
by Dfreehd
Where are the modules? Are they inside the housing or somewhere else? The lenses are typical condition cloudy and with holes drilled for the strobes but work properly with no broken tabs. Hope that helps.

Re: 2012 Part out

Posted: Mon Dec 09, 2019 9:45 pm
by 20129C1
PM sent.

Re: 2012 Part out

Posted: Tue Dec 10, 2019 10:47 am
by CrashTestDummy
Dfreehd wrote: Mon Dec 09, 2019 8:39 pm Where are the modules? Are they inside the housing or somewhere else? The lenses are typical condition cloudy and with holes drilled for the strobes but work properly with no broken tabs. Hope that helps.
Okay, housings. I guess I'll pass, since the one on our '12 are fairly clear, but do show some separation. There are no holes in ours, though. Thank you for checking.

Re: 2012 Part out

Posted: Mon Dec 16, 2019 8:55 am
by 20129C1
Did you get my PM?

Re: 2012 Part out

Posted: Wed Jan 01, 2020 12:53 pm
by Dfreehd
I am not good about checking my messages on here so for parts inquiries you can email me at DFREEHD@Comcast.net.

Thanks to those of you who have reached out so far!

Re: 2012 Part out

Posted: Wed Feb 26, 2020 5:17 pm
by Sir_Salaam
I could use the front passenger and driver seat belt retractors. PM sent.