Page 1 of 1
Build sheet location “ original “
Posted: Sun Feb 21, 2021 9:36 pm
by Nilfol
Hello everyone,
Where does gm put the factory build sheets in these cars?
I know a lot of the Chevy’s in the 70’s where placed behind the seat of above the gas tank.
Anyone find theirs?
Re: Build sheet location “ original “
Posted: Mon Feb 22, 2021 9:20 am
by Pursuit
The manufacturers use an SPID label, Service Parts Identifier. On our cars it is attached to underside of the spare tire cover. It contains all of the RPO codes/options for that vehicle. Just verify that the VIN on the label matches your car VIN. Sometimes the spare tire carrier is removed to accommodate in-service equipment. When the car goes to auction, they may just throw in what ever spare tire cover is lying around in storage.
Regards,
Maurice
Re: Build sheet location “ original “
Posted: Mon Feb 22, 2021 10:46 am
by CrashTestDummy
Pursuit wrote: ↑Mon Feb 22, 2021 9:20 am
The manufacturers use an SPID label, Service Parts Identifier. On our cars it is attached to underside of the spare tire cover. It contains all of the RPO codes/options for that vehicle. Just verify that the VIN on the label matches your car VIN. Sometimes the spare tire carrier is removed to accommodate in-service equipment. When the car goes to auction, they may just throw in what ever spare tire cover is lying around in storage.
Regards,
Maurice
OR, a cover with no SPID label at all!
Re: Build sheet location “ original “
Posted: Mon Feb 22, 2021 1:20 pm
by JRWolff
You can also provide your VIN to the dealer (parts or service) and they can print out a complete build sheet for your car that includes all the RPO or SPID codes including descriptions. The dealer that i use was more than happy to do this for me.
Re: Build sheet location “ original “
Posted: Mon Feb 22, 2021 7:25 pm
by Hesher
Even easier, you can email
socialmedia@gm.com with your vin number and ask for a buildsheet. They then send it over!
Re: Build sheet location “ original “
Posted: Sun Feb 28, 2021 11:18 am
by redsled579
x2 on the
socialmedia@gm.com. emailed them at 10:00pm, and 8:30 am had a pdf of all my rpo codes with descriptions.