Side Repeater Mods

Electronic systems, stereo and Holden iQ, wiring, it all goes here....
Post Reply
Silversled
Posts: 270
Joined: Fri Aug 12, 2016 7:13 am
Location: Tampa, FL

Side Repeater Mods

Post by Silversled »

I had my paint and body guy paint the repeater trim panels for me a while back and since I didn't have time to address the wiring, I just drove with them for month installed but not functioning.

Image
Image

I liked them just fine but since I was already blacking out the car, I wanted to experiment with darkening the chrome center. I decided to use the Dulicolor Shadow Chrome Blackout kit to tint the chrome a few shades.

Image

A few swipes of the razor blade and other sharp tools separated all the parts. I noticed that the circuit board that housed the LEDs had resistors installed which was promising. I was hoping I wouldn't have to install additional resistors to correct the typical hyperflash issue when installing LEDs with normal bulbs.

Image

Using some black silicone adhesive/sealant, the repeaters were reassembled with care.

Image
2014 Chevrolet Caprice PPV
2014 Chevrolet Stingray Z51
2016 AMG C63
2015 BMW X5 iDrive 50i
Silversled
Posts: 270
Joined: Fri Aug 12, 2016 7:13 am
Location: Tampa, FL

Re: Side Repeater Mods

Post by Silversled »

After some previous posts about the repeater wiring from smwalker and Crazy Paul, and hunting though pages of schematics, the most convenient place to tap into the turn signal wiring would be just at the connector going into each headlight housing. This would mean the following wires would need to be tapped:

Driver Signal: Blue/White
Driver Ground: Black

Passenger Signal: Green/Violet
Passenger Ground: Black

Image

I disconnected the main connector going into each headlight to give me a little more room to cut the electrical tape and expose the wires to tap them. The reddish lock needs to be pulled up as the connector is pulled off.

Image

The appropriate wires were exposed and identified, then I just tapped them to a 2-P waterproof connector. The bundle was then taped with high temp electrical tape and neatly zip tied so it wouldn't pull or move around.

Image

Image

The driver's side:

Image

Video coming soon....
2014 Chevrolet Caprice PPV
2014 Chevrolet Stingray Z51
2016 AMG C63
2015 BMW X5 iDrive 50i
Silversled
Posts: 270
Joined: Fri Aug 12, 2016 7:13 am
Location: Tampa, FL

Re: Side Repeater Mods

Post by Silversled »

2014 Chevrolet Caprice PPV
2014 Chevrolet Stingray Z51
2016 AMG C63
2015 BMW X5 iDrive 50i
smwalker
Administration Staff
Posts: 2201
Joined: Mon Jul 29, 2013 1:44 am
Location: Azusa,CA

Re: Side Repeater Mods

Post by smwalker »

Very Nice!!

I Like the 2 conductor connector you used to make the harness serviceable. Very nice.

Like the fact that we can change the color of the chrome, Revolutionary!

Hate those Red pierce the wire type connectors, given me nothing but trouble of the years, hope yours work fine.

Thanks for sharing!

Need a final pic with those black beauties installed!!
Steve Walker
Azusa, CA
'11 PPV 9C3 Huron White
Silversled
Posts: 270
Joined: Fri Aug 12, 2016 7:13 am
Location: Tampa, FL

Re: Side Repeater Mods

Post by Silversled »

smwalker wrote:Very Nice!!

I Like the 2 conductor connector you used to make the harness serviceable. Very nice.

Like the fact that we can change the color of the chrome, Revolutionary!

Hate those Red pierce the wire type connectors, given me nothing but trouble of the years, hope yours work fine.

Thanks for sharing!

Need a final pic with those black beauties installed!!
Thanks Steve. I'll definitely add to the post when I have it physically wired and installed.

Yes I agree about those taps. They normally suck and I usually stay away from them. Frankly, I was lazy and had them lying around so grabbed them. Considering it is not a critical item, I'm not too concerned. We'll see how long they last.
2014 Chevrolet Caprice PPV
2014 Chevrolet Stingray Z51
2016 AMG C63
2015 BMW X5 iDrive 50i
Silversled
Posts: 270
Joined: Fri Aug 12, 2016 7:13 am
Location: Tampa, FL

Re: Side Repeater Mods

Post by Silversled »

Boy it's hard to find time to work on my cars these days. I finally got the side repeaters re-installed and plugged in. Works great.

Image

Image
2014 Chevrolet Caprice PPV
2014 Chevrolet Stingray Z51
2016 AMG C63
2015 BMW X5 iDrive 50i
ls1mike
Posts: 39
Joined: Sat May 21, 2016 12:32 am

Re: Side Repeater Mods

Post by ls1mike »

I love it. Looks great!

Where did you get yours?
Mike Friend
2014 Caprice PPV 9C1
2000 Trans Am WS6
2015 Turbo Malibu
2002 Silverado 2500HD
KKARSTEN
Posts: 24
Joined: Mon Mar 07, 2016 7:25 pm
Location: Northwest Indiana

Re: Side Repeater Mods

Post by KKARSTEN »

Looks great tinted like that! I thought about those snap taps, then decided no, but I do like the idea being able to take them off and with a little tape, good as new.

I should have all my things painted and installed next week. Getting excited after seeing yours. A little inspiration...
Kyle Karsten
Post Reply