New Caprice - Discussion forums

Anyone here ever need to replace weather stripping, specifically lower door seals? I can find the front door seals, but am struggling to find the rear door seals. I can find the lower seals for the front doors. It is just one straight piece. 92280415. I believe this works for both left and right sid...

Installed dual exhaust tips.


......Just kidding

Fandango wrote: ↑Tue Feb 01, 2022 8:49 am I got the rear Tein springs installed on new Monroe shocks/struts. The car looks much better now lowered all around.

What part number Tein springs did you use?

2015 Caprice Rear Speaker Upgrade/Install 8 Some details on the amp wiring, specifically the remote wire. As mentioned in an earlier post, the amp is hidden behind the trunk liner near the primary battery and fuse panel (driver side). The main 12V+ power for the amp is connected directly to the batt...

2015 Caprice Rear Speaker Upgrade/Install 7 ....and a few more details on the speaker relocation. After drilling the 5.5"(140mm) and 5/16" holes you can push the grill through the 5/16 holes. Turn the panel over and cut away some insulation, place the speaker on the screw bosses, then appl...

If anyone is looking for the OEM-speaker relocation grill, then PM me. I can print and ship the parts to you. See this for details on install: http://www.newcaprice.com/forum/viewtopic.php?f=36&t=4792#p34888 Looking back at this and knowing how much space behind the door panel I actually had, I ...

Hey all- I added some more detail on the rear door speaker grills on my build page. http://www.newcaprice.com/forum/viewtopic.php?f=36&t=4792#p34888 If you would like to buy the speaker grills from me, then just PM me on this forum. I'll send 2 grills, 2 templates, and 6 thread-forming screws ki...

2015 Caprice Rear Speaker Upgrade/Install 6 Adding some details on the speaker grill install........ After 3D printing the speakers I applied a bit of 5-minute epoxy to strengthen the base of the screw bosses. Not sure if needed, but added to be safe (these are 3D printed after all). glue.jpg For dr...

The SS factory subs sound pretty darn good to me with the XMS400D amp. You aren't going to turn any heads with the amount of bass, but for everyday listening on your drive to and from work they sound great. You definitely need the rear door speakers running for mid/high range to compliment the subs....

I covered the entire area where I wanted to put the speaker with blue painter's tape. Then I put the speaker grills where I wanted them and drew a circle around the outside and marked the screw holes. I used the screw hole marks to draw an "X" to find the center of the hole. Then I used t...