It all started with wanting cup holders; 2015 Chevy SS Dash

Discussion on body issues/mods, appearance, interior/trim, and detailing (i.e. how to keep your car looking showroom new, or a reasonable facsimile thereof...).
impalaplt
Posts: 67
Joined: Fri Jun 18, 2021 3:50 am
Location: Tucson, AZ

Re: It all started with wanting cup holders; 2015 Chevy SS Dash

Post by impalaplt »

Well, I "THINK" I've got all the parts for this conversion, but I still have a couple questions that I haven't seen addressed.....

When you install the floor shifter, did you use the rod for the Chevy SS (Now on national backorder), or a Camaro one?
(They look about the same.....)

What does it take to eliminate the column shifter? And, what do you do about the hole in the dash?

I'm sure I'll come up with more as I go along, but I have to dig into it.

But, I have to send the Radio/Silver box, the instrument cluster, and the HUD off to White Automotive to get programed.....
smwalker
Administration Staff
Posts: 2201
Joined: Mon Jul 29, 2013 1:44 am
Location: Azusa,CA

Re: It all started with wanting cup holders; 2015 Chevy SS Dash

Post by smwalker »

Just wanted to add my 2 cents in here.

If you are keeping the parking brake adjuster and cutting your ducts to fit around it there is one more piece you need to cut off of the console assembly. At the bottom the cup holder well there is a nub for a screw that went in to the cut out part of the ducting. It lands right on the parking adjuster so a chop out is in order. This gets the front mounting bolts to come down a bit more to meet up perfect with the floor mounts.

Before:
IMG_20220828_130308.jpg
IMG_20220828_130308.jpg (492.98 KiB) Viewed 441 times

After:
IMG_20220828_130617.jpg
IMG_20220828_130617.jpg (450.6 KiB) Viewed 441 times

In place (viewed from cup holder side) you can see the adjuster slides right on the bottom of the cup holder.
IMG_20220828_132849.jpg
IMG_20220828_132849.jpg (466.35 KiB) Viewed 441 times
Steve Walker
Azusa, CA
'11 PPV 9C3 Huron White
Post Reply