Hello, I've searched the key words maybe not with the right ones, has anyone replaced the WN series air blend door actuators? If so, what is their location and any pictures would be much appreciated.
Thank yiou!
2014 air blend door actuator replacement
-
- Posts: 162
- Joined: Sun Nov 18, 2018 2:23 am
Re: 2014 air blend door actuator replacement
Have you hooked up a decent scan tool to check for fault codes?
Re: 2014 air blend door actuator replacement
I did some videos that might help:
https://www.youtube.com/watch?v=-MDVCXUHYzI
https://www.youtube.com/watch?v=y3Dzquf1K24
https://www.youtube.com/watch?v=-MDVCXUHYzI
https://www.youtube.com/watch?v=y3Dzquf1K24
-
- Posts: 162
- Joined: Sun Nov 18, 2018 2:23 am
Re: 2014 air blend door actuator replacement
Thanks Steve your videos are VERY helpful!
One question, which actuator would you say controls the mix of warm and cool air? My situation is, at first I had warm air blowing on the passenger side, cool on the driver side with both sides set to LO temperature setting, then both sides put out warm air, I hade the system completely evacuated and recharged this brought back cool, not cold air on the drivers side, now after winter it is again, warm, checking the system, it still shows full, so is my HVAC mixing warm air when it should not?
Again, thanks!
One question, which actuator would you say controls the mix of warm and cool air? My situation is, at first I had warm air blowing on the passenger side, cool on the driver side with both sides set to LO temperature setting, then both sides put out warm air, I hade the system completely evacuated and recharged this brought back cool, not cold air on the drivers side, now after winter it is again, warm, checking the system, it still shows full, so is my HVAC mixing warm air when it should not?
Again, thanks!
-
- Posts: 162
- Joined: Sun Nov 18, 2018 2:23 am